Review of Kanger KONE E-cigarette Starter Kit and PANGU Atomizer.

This is Kanger KONE Starter Kit. Here is the authenticity verification sticker. It is black color. This is the card for how to verify the authenticity. This is the user manual. In the kit, it includes 1pc PANGU atomizer, it is pre-installed 1pc PGOCC heating coil inside, 0.5ohm, the heating wire is made of stainless steel 316L. This is the KONE box mod body, very small. Here is the usb charging cable, and charging hole. Kone box mod has built in 3000mAh battery, so you do not need to purchase a separate battery. This is replace seal ring and glass tube to PANGU atomizer.

Let’s fill some e-liquid into PANGU. Then click 5 time to active the KONE. The led screen shows the battery level from 1 to 5 points, it is 4 points right now. Then you could start to vape. You do not need to adjust the watt of the box mod any more, it is a smart MOD, which will adjust its output power automatically to fit to the atomizer. Let’s try another atomizer, the resistance of PANGU shows at around 0.6 ohm at my reader, this UD EZ RTA atomizer shows at around 0.2ohm. It also works very well with KONE. Let’s come back to PANGU atomizer. You could adjust the juice hole to control the eliquid amount in the heating coil. You could turn the hole smaller to reduce the vapor amount a little bit. It is more convenient for you to replace the heating coil. You do not need to open the tank and touch the eliquid any more. You just need to turn around the atomizer to make the eliquid level is lower than the juice hole, then take it off. Your hands could keep clean. If you need to replace PANGU atomizer, you could also purchase it separately. There is no extra PGOCC heating coil in the KONE kit, PANGU atomizer has no RBA deck, so you may need PGOCC heating coil as well.

Share